Unique Moving Supports Reduce 3D Printing Waste by 35%
While additive manufacturing (AM) may save substantial amounts in terms of material waste compared to subtractive techniques, AM is not without its own subtractive procedures, namely in the post-processing of prints. Depending on the specific 3D printing method used, there may be significant support structures that need to be removed from a print. Researchers at USC Viterbi’s Daniel J. Epstein Department of Industrial and Systems Engineering have come up with a novel way to reduce this in fused filament fabrication (FFF).
In an article for Additive Manufacturing, Yong Chen, professor of industrial and systems engineering, and PhD student Yang Xu, describe their method for a dynamically-controlled 3D printing substrate. Inspired by pin impression toys, the team created a print bed made up of a series of square washers connected to rods controlled by a single stepper motor. The rods and washers move to the necessary heights to support the object in various locations.
The team first demonstrated their technique for an arbitrary CAD model, completely replacing the need for printed support structures. For more complex geometries, printed supports were still needed. The metal squares would raise to a point and the remainder of the required support would be printed atop those metal pieces. Once the prints were complete, the researchers could easily remove the washers.
According to Chen, this method could reduce material waste by about 35 percent, which can have a significant impact particularly when it comes to more expensive feedstock.
Chen also spoke to the speed savings of using reusable supports: “When you’re 3-D printing complex shapes, half of the time you are building the parts that you need, the other half of the time you’re building the supports. So, with this system, we’re not building the supports. Therefore, in terms of printing time, we have a savings of about 40%.”
While there have been similar projects in the past, they relied on individual motors, which naturally resulted in higher costs and energy use. With 100 moving pins attached to $10 motors and 25 boards to control something around 100 motors, the machine would easily cost more than $10,000.
The researchers are already examining ways that the technique could be applied to other 3D printers, such as large-scale systems like the Big Area Additive Manufacturing machine from Cincinnati Incorporated, as well as for other technologies.
via 3DPrint.com | The Voice of 3D Printing / Additive Manufacturing https://3dprint.com
April 7, 2021 at 08:36AM